Lights
Ward Leonard manufactures and supplies a broad array of lighting solutions for your rugged requirements. Our indicator lights are incandescent or light-emitting diode (LED) and handle voltages from 117V to 440V AC or DC. Indicator Lights are available with red, green, amber, blue, white and clear color lenses as well as flashing lamps and watertight units.
The Dualamp Indicator Light revolutionizes the single lamp concept. When there is only one lamp and it is not lit, it may mean a real signal indication or just a burnt out lamp. This element of doubt is eliminated with the Dualamp since no two lamps burn out simultaneously. When both lamps are out it means a real signal indication. The Dualamp Indicator Light uses 2.5 volts alternating current (VAC) lamps in parallel which are independently supplied by a 1.8 VAC closely regulated transformer for a long lamp life. Depending on the indicator light selected, it can be used on voltages such as 117 or 450 VAC. Dualamp Indicator Lights are also available for direct current voltages (VDC). Inquiries on other line voltages that may not be listed are invited. Hardware (Oring, hex nut, cup washer) are included. Midget screw base lamps and lenses are purchased separately.
LH 94 Indicator Light
|
The Dualamp Indicator Light has been tested and approved for dielectric withstanding voltage, moisture resistance, voltage regulation, temperature rise, shock, vibration, visual and dimensional. Application with 50, 60, or 400 Hz A.C. systems. View Specifications  |
LH 95 Indicator Light
|
The Dualamp Indicator Light lampholder is used for direct current applications and where personnel safety must be obtained without putting a ground on the system. The lamp sockets are recessed into an insulated core and the circuit is automatically disconnected when the lens is removed to replace the lamps. The two lamps are connected to separated resistors thereby featuring the same Dualamp advantages. Lamp Accomodation: W-L-00111/46 (Industry #342; MS15612-5) View Specifications |
LH 96 Indicator Light
|
The Dualamp Indicator Light lampholder is used for direct current applications and where personnel safety must be obtained without putting a ground on the system. The lamp sockets are recessed into an insulated core and the circuit is automatically disconnected when the lens is removed to replace the lamps. The two lamps are connected to a resistor contained within the unit. View Specifications |
LH 98 Indicator Light
|
The LH 98 Dualamp Indicator Light has been tested and approved for dielectric withstanding voltage, moisture resistance, voltage regulation, temperature rise, shock, vibration, visual and dimensional. Application with 50, 60, or 400 Hz A.C. systems. View Specifications |
Lenses
|
Lenses are compatible with our line of indicator lights. View Specifications |
